Wonderfire Eclipse 654 Bedienungsanleitung PDF herunterladen (Seite 42)

INSTALLER’S GUIDE

Page 42

Figure 45. Burner plaque positions

14.9 To Replace Burner Plaques

See figure 45.

1. Remove the ceramic fuel effect

pieces.

2. The plaques can be then be removed

as follows without detaching the

front surround.

Be careful not to scratch the

burner cover or reflector when

working in the hotbox.

3. Remove the plaque clamping strips

by detaching 6 screws.

4. Remove the plaques and the

combination gasket between and

under the plaques. If necessary

remove the gauze and the gasket

beneath it.

5. If necessary fit a new gasket below

the gauze. Clean and replace the

gauze. Fit a new combination gasket

below the plaques. Push the gasket

ends inwards to form a dividing

gasket between the plaques.

6. Place the new left hand plaque in

position. The left hand plaque is

sand colour and has 17 slots. The

left side of the plaque must touch

the inside edge of the retaining

flange at the left side of the burner

well.

7. Place the new right hand plaque in position. The right hand plaque is white and has 15

slots. Make sure that the centre section of the combination gasket is between the two

plaques. If there is any play between the plaques and the end retaining flanges, push

the plaques firmly to the left squeezing the centre section of the combination gasket

between the two plaques. Any gap should be between the right side of the plaque and

the right side-retaining flange.

8. Fit the front and rear plaque clamping strips. Make sure that the plaques are as far to

the left as possible. . It is important that the left side plaque is accurately positioned

so that it has the correct relationship to the pilot. Fully tighten the clamping strips.

1 2 ... 37 38 39 40 41 42 43 44

Keine Kommentare

Wonderfire Eclipse 654 Bedienungsanleitung Seite 42