Wonderfire Eclipse 654 Bedienungsanleitung PDF herunterladen (Seite 27)

INSTALLER’S GUIDE

Page 27

9.6 Check reference pressure.

The appliance is pre-set to

give the correct heat input at

the inlet pressure shown

within Appliance data

section of this manual. No

further adjustment is

necessary. The burner

pressure should be checked

by fitting a pressure gauge at

the test point accessible to

the right of the control knob

(See figure 24). The pressure

should be checked with the

appliance alight and the control set at ‘HIGH’. After checking the pressure, turn off the

appliance. Remove the pressure gauge and replace the test point sealing screw. Re-light

the appliance. Turn to ‘HIGH’ position and test around the sealing screw for gas

soundness using a suitable leak detection fluid.

Figure 24. Pressure test point position

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Keine Kommentare

Wonderfire Eclipse 654 Bedienungsanleitung Seite 27