Wonderfire Eclipse 654 Bedienungsanleitung PDF herunterladen (Seite 25)

INSTALLER’S GUIDE

Page 25

9. BURNER & SUPPLY PIPE

INSTALLATION

9.1 Fitting the Burner

1. Place the burner module into the hotbox.

2. Refit the burner cover by lowering it onto the

burner module. The front edge of the burner cover

should locate in front of the burner module. The

sides of the burner cover should locate behind the

front of the burner module. Secure with two screws

removed previously (See figure 22)

3. Refit the Inner Reflector into the hotbox. Be

careful not to scratch the top surface of the burner

cover. Secure using six screws removed previously.

4. Refit the spillage plate. Secure using the four

screws removed previously.

9.2 Supply pipe installation

A nut and olive is provided for an 8mm-pipe inlet

connection directly to the gas control. The isolating

elbow can be rotated to allow a connection from any

direction. The elbow includes a valve for isolating

the gas supply.

The supply pipe must be rigid material. Flexible

pipe must not be used. Connect the supply line to the appliance.

Pressure check the installation pipework for gas soundness in accordance with the current

edition of BS6891.

Concealed Supply Pipe Connection

If a concealed connection from inside the fireplace is required then, before the

appliance is fitted into the fireplace it will be necessary to extend the supply line so

that it will project through the chosen removable circular panel at the back of the hotbox

and run to the elbow at the front. The pipe run from the supply line up to the rear opening

in the hotbox must be kept away from the area which will be taken by the hotbox when it

is installed (See figure 7).

Note that the centre of the appliance inlet elbow is 25mm above the fireplace floor.

Figure 22 Burner cover location

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Keine Kommentare

Wonderfire Eclipse 654 Bedienungsanleitung Seite 25